View Single Post
Unread 05-22-2009, 01:38 AM   #114
LeckembyBrosCustoms
Found some matches.
 
Join Date: 05-20-09
Location: Colton Ca
Downloads: 0
Uploads: 0
Default

Reasons you will need a punch to make a starter "dimple" in the metal, this will allow you to drill a pilot hole. Once you have the hole you can use a step drill bill. You can see it in Norco's pictures it looks like a little golden pyramid. go slow and extend the hole just enough to accept the metal threaded pipe this will be important if you want to use the lock nuts rather than weld them. As for the burn out I just started a really good fire and it got most of the liner out the weed burners are pretty cheap here in So California we have a tool place called Harbor Freight not the greatest quality but it is inexpensive. Please feel free to email me if you get stuck. Good Luck Dan
LeckembyBrosCustoms is offline   Reply With Quote