View Single Post
Unread 05-08-2009, 01:38 PM   #3099
Tangled Up In Q
Found some matches.
 
Tangled Up In Q's Avatar
 
Join Date: 10-30-08
Location: Jacksonville, FL
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by Barbarian View Post
Hey Phubar,
Here are my intakes. I made the back on a bit taller so it would be easier to get to since I have a table close by and cannot walk around the drum. The front one is a bit shorter and the other two are down at the bottom but are only open for about 5 minutes when I fire the drum up, then they are shut down. On the tall ones I use a magnet to adjust the air.

I like the 2" exhaust. It works great since I have a airtight drum now. I use a tin can to put over the exhaust to slow it down before turning the meat and to shut it down after the cook.

Not quite sure what your pic shows, maybe another one later will help. Good luck with the build.
Barbarian, that is one awesome looking UDS, you may have to drop the U ! Hope you don't mind I am going to try to clone it! I will change up the paint scheme for sake of identity. Both drums I have are closed drums, was yours an open ended??
Tangled Up In Q is offline   Reply With Quote