View Single Post
Unread 05-06-2009, 02:35 PM   #3053
ytsejam
Full Fledged Farker
 
ytsejam's Avatar
 
Join Date: 10-10-08
Location: dfw
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by StayDown View Post
Does the lid sit down inside the lip roll or did you take that off and it just sort of sits precariously on top?


I am thinking you might want to shave some mro metal off and use some high temp rubber around the inside of the drum at the very top. Then make the lid to snugly squeeze down, causing a press type fit....but that is just the machinist/ designer in me.
It just rests on top. I flattened the rim of the lid out to rest on top of the drum.

I got the temp down to 250, then opened one air vent about 1/8 of an inch, and left for 3 hours. when i got back it was at 275.

I just but some MOINK balls, and some chicken lolly pops on. and going to get a couple fattys on in about 30 mins. so we will see what that does to the temp
ytsejam is offline   Reply With Quote