View Single Post
Unread 03-16-2009, 08:53 PM   #2614
Norcoredneck
somebody shut me the fark up.
 
Norcoredneck's Avatar
 
Join Date: 07-11-06
Location: Norco, Ca.
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by BarberQue View Post
He told me they get it up to about 150 degrees and then spray it so it dry's quick and then they bake it between 5-600 dgrees to cure.
It doesn't exactly spray. Don't want to seem like a know it all but my dad was in on the beginning of the powdercoat process. He ran a wheel company. They bought one of the first powder coat lines sold. Ithe clean piece is electracally (?) charged and so is the powder. A low pressure air or kinda "poof" is blown on the part and it is drawn to the part. Then it is put in the oven. Process is great. 400 is the minimum temp to start process. About the only way I had ever seen him get it off or strip it is with extreme temps. Great coating.

Old man used to blow a gasket when someone would ask him to "Dip" this in chrome!
__________________
Low and Slow.....

The Prontologist is in...
Ok let's see your Butt!
Norcoredneck is offline   Reply With Quote