View Single Post
Old 03-03-2009, 07:04 PM   #2523
Norcoredneck
somebody shut me the fark up.
 
Norcoredneck's Avatar
 
Join Date: 07-11-06
Location: Norco, Ca.
Default

Quote:
Originally Posted by 2K1TJ View Post
Just finishing up my new UDS. I have a question that I haven't seen mentioned.

Do you remove the gasket around the drum lid? I know it'll seal better with it, but I'm afraid it'll melt and/or give off gasses or fumes from heating up.

Definately. Some come out easily, some not. If you have difficulty heat it a little, use a toothbrush type wire brush followed by WD40 and a little brushing and wash with a degreaser, or handful of Tide in warm water.
__________________
Low and Slow.....

The Prontologist is in...
Ok let's see your Butt!
Norcoredneck is offline   Reply With Quote