View Single Post
Old 02-25-2009, 07:43 PM   #2488
somebody shut me the fark up.
Norcoredneck's Avatar
Join Date: 07-11-06
Location: Norco, Ca.

Originally Posted by Weiser View Post
Do you need three 3/4" nipples plus the valve with a 85?
Just curious as to what the difference is regarding the intakes
with an 85 VS a 55.

Prolly stupid but... what about the standard eight hole exhaust?
Do the number of holes need to be increased or, perhaps opened up to 5/8"

I actually use my "Redneck Guru" on this. I open one, valve open, start fire. Build temp, cap one, go 1/2 valve and turn on redneck guru and it controls nicely. I have a weber type lid so don't know on lid holes. i woyld go standard 8 1/2" to start. Easier to open up than replace material if not enough exhaust.
Low and Slow.....

The Prontologist is in...
Ok let's see your Butt!
Norcoredneck is offline   Reply With Quote