Quote:
Originally Posted by drez77
I have got through about 50 pages of this thread. A lot of good information in here. I have a 30G barrel laying around. My question is, will this work OK for a UDS? I know it will be smaller and might need a water pan. My plan is to use this for a trial run before I find a 55g drum. Any thoughts?
Mike
|
I think DR.Ky made his first from a 30Gal.
Quote:
Originally Posted by jd-santaclarita
Guys - I am looking for some details on the intake pipe nipples. How long should they be? 1" long close nipples? Do they need to be stainless? I am not sure what they have over at home deeps, but i doubt its stainless...
Since i am not welding, just to make sure i got this right....I can thread in the 3/4" pipe nipple and on the inside i can lock it down with a conduit nut and same on the outside? I doubt the threading of the ball valve will thread all the way down to the barrel.
Thanks all,
JD
|
1" length will do fine, Black Pipe nipples are what they're called and you can use a single conduit nut on the inside and it will work fine.....