[Dr_KY]

Originally Posted by dresselbrew

I was having a problem getting up to a high temp so I added them. I have three 1/2" nipples and am running them wide open. I can hold steady at 220° which is fine for most of what I want but was looking to be able to get a higher temp for other things. Might need to add another inlet?

Why do you think the extra holes in the lid will be a problem?

If your temps wont rise then you are going to need more intake. I use two 3/4" intakes and just the 2" exhaust. I run with one wide open and adjust with the other.

Wide open..


Adjust temp..



Exhaust..