View Single Post
Unread 10-02-2008, 11:13 PM   #1645
garyk1398
Babbling Farker

 
garyk1398's Avatar
 
Join Date: 08-05-08
Location: South O, Omaha, NE
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by ON THE FARM View Post
The way I do it is find the seam that runs up the drum, make a mark 18" on both sides of the seam (near the bottom), this will give you your side hole marks.
Measure 18" from the marks you just made, yes you will find out that they will over lap.
Now split the difference between the over lapping marks and that is the center or your front hole location.
No what I do is measure 2" from the bottom lip of the barrel and pop my intake holes.
Sounds like you are referring to 4 intake holes...right? How about the small ones for the racks? Do the same thing?
__________________
Cookshack sm055, UDS, Smokey Joe, Southwest Pit, couple of Weber kettles, an old gasser, and a weed burner.

Gary, KCBS -CBJ
Certified Nebraska MOINK Baller, KCBS - CBJ
Semper Fi, when in doubt empty the magazine
garyk1398 is offline   Reply With Quote