All enamel around the edge chipped off. Sad cuz this lid is way better than the one on my other drum.
I bent that flange out just about flat, laid the lid on top and pounded down the sides with a hammer. Since that sucker sits on casters all I did was spin it(while tapping with the hammer) till it fit again.
I was thinking of using swamps lid method, but it all worked out. I just sand and paint the chipped edges.
Sidartha translated: Every wish fullfilled
True stainless kegerator w/cheap 1/2 barrel
10'6 EC single fin
10' Minchington 2-1 set up