Originally Posted by Single Fin Smoker
Anybody ever have issues with getting your kettle lid to fit?
I just bent the chit out of mine to get it to fit.
Kev, I had to bend mine up bad too as my lid was out of round. I just repainted the whole lid with hi-heat black to match the drum. You can still see where the enamel flaked off along the lip but I can live with that. I think if I did it again I would sand it down before painting but then again that would take the UGLY
out of UDS
Horizon 20" Classic stickburner, Horizon Patriot grill, UDS by Norco, Backwoods Patio, Weber Spirit E-310
Lang 36, Lang 60, Large Spicewine, BWS competitor, BWS party, custom 6ft stickburner/trailer,
Oklahoma Joe's Longhorn, WSM 18", Chargriller offset. My name is Rob and i have a barbecue problem.