View Single Post
Unread 08-15-2008, 04:35 PM   #1472
BobF
Take a breath!
 
BobF's Avatar
 
Join Date: 07-13-08
Location: Savannah, GA
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by Single Fin Smoker View Post
Anybody ever have issues with getting your kettle lid to fit?
I just bent the chit out of mine to get it to fit.
Yep, did the same thing. Had to bend the lowest flange out to make it fit the drum. I wrapped my pliers with tape to try to lower the amount of enamel that chipped off, but I don't think it helped much. Just bend as needed and live with the result.
If you are lucky your lid will fit with no bending. Seems some have found this.
__________________
OTS Kettle, UDS, Sam's Gasser
BobF is offline   Reply With Quote