I never found a Weber lid that fit and I wanted to build my own lid anyway. So I use the weber lid on the weber rotis extension where it was made to fit.
So I made a 10" tall one with the bottom of a donor drum and welded roundbar that meets the drum lip and then a flatbar to slide over the lip.
I made a 6" one (for the UDG) using the lid of a closed drum and the lid from a flat drum. Cut the center out of the flat lid and welded it to the top 6" of the donor drum.
Both have a 2" pipe nipple exhaust because I need to exhaust the smoke out of my little covered Q shack.
Drumhead - UDS x 2 & UDG
Keep on Smokin'
KC native missin' KC
IMBAS Certified MOINK Baller 2009
I also support PETA - People Eating Tasty Animals
Last edited by Barbarian; 11-19-2009 at 08:34 PM..