View Single Post
Old 06-09-2008, 09:31 PM   #66
is One Chatty Farker
Barbarian's Avatar
Join Date: 11-07-07
Location: Middletown California

Norco, a good little tool you might want to add to your tutorial for the conduit nuts is a "shower valve socket wrench". The size for a 1" nipple is 1 9/32". They are much easier then the "primative Pete mod". If you use two, one on the inside and one on the outside you can tighten the nuts down great.

If you have to vent smoke out like I do in my little Q shack then a 2"od by 4" pipe nipple works good. I also used conduit nuts on the exhaust pipe, one inside and one outside nice and solid. The 2" pipe seems to be the correct amount of exhaust also. I use a 3" dryer vent and put a tin can inside the vent with hose clamps to make it stronger and stable so hopefully last longer from taking it on and off the exhaust. Also made a little handle because the ventpipe gets a bit hot, especially on my UDG.
aka Barbarian

Drumhead - UDS x 2 & UDG
Keep on Smokin'
KC native missin' KC
IMBAS Certified MOINK Baller 2009
I also support PETA - People Eating Tasty Animals

Last edited by Barbarian; 11-19-2009 at 07:34 PM..
Barbarian is offline   Reply With Quote