View Single Post
Old 04-15-2008, 11:45 AM   #10
Take a breath!
Beerwolf's Avatar
Join Date: 06-03-07
Location: Cloverdale, Ca

You guys are too complicated.... Just take a crescent wrench to the webber lid, barely open the wrench and use it to bend out the lip. You will have to do this about every 1/2 inch or so as you go around the lip, it wont even break the paint and its a lot better than thrashing a good webber kettle bottom which can be used later as a redneck fire pit
"Assumption is the Mother of all F___ups!"
Beerwolf is offline   Reply With Quote