View Single Post
Old 02-07-2014, 11:23 AM   #11693
Bludawg
somebody shut me the fark up.
 
Bludawg's Avatar
 
Join Date: 07-04-09
Location: Jonesboro,Tx
Default

Quote:
Originally Posted by knitmar View Post
I am nearly at the same stage of progress as you are, so I can't contribute an answer to your question. But I'd like to pose a question to you - how did you determine/measure the correct length to cut the 2 x 1/8 aluminum. I keep coming up with lengths varying up to a half inch. It loks as if you hit it on the button. Nice job, hope you get quick answer to your gasket question.
3.14167 X the actual dia.= the circumference This is the length of the Strip
__________________
I'm a Proxy Vegetarian> Cows eat grass & I eat cows.
Bludawg is offline   Reply With Quote