View Single Post
Old 02-07-2014, 01:31 AM   #11686
Is lookin for wood to cook with.

knitmar's Avatar
Join Date: 12-22-13
Location: Clearwater, FL

I am nearly at the same stage of progress as you are, so I can't contribute an answer to your question. But I'd like to pose a question to you - how did you determine/measure the correct length to cut the 2 x 1/8 aluminum. I keep coming up with lengths varying up to a half inch. It loks as if you hit it on the button. Nice job, hope you get quick answer to your gasket question.
knitmar is offline   Reply With Quote