View Single Post
Unread 12-09-2013, 06:34 PM   #7
Quintessential Chatty Farker

Fwismoker's Avatar
Join Date: 08-22-13
Location: Fort Wayne, indiana
Downloads: 0
Uploads: 0

Originally Posted by ebijack View Post
I don't think your going to drill thru any quality S.S. with a step drill. Cutoff wheel yes. Torch, yes. Just so you know.
Yes you can...I did it with a 80 Qt stainless pot. At first it was hard and then i figured it out. The key was laying it on it's side and starting with a fat 1"step bit, then switching to a smaller size...after it starts it's easy Use lube

See this thread.
*** If you think this post is stupid, dumb, lame then don't read it. Nothing good to say? ....say Nothing.***
New Addition! Dedicated stick burning/charcoal UDS Rotisserie!,
Lou -Mini WSM uds style,
Jaime- Jumbo mini or Jimmy
Black bullet -newly renovated Big Poppa Black powder coated UDS,
Jaime build-
Fwismoker is offline   Reply With Quote

Thanks from:--->