View Single Post
Old 11-05-2013, 05:33 AM   #11564
is One Chatty Farker

ebijack's Avatar
Join Date: 08-23-13
Location: Michigan

Mig here too. .023 wire, clean the paint off where your going to weld just like any project, clean the paint off for the ground and have at it. I -welded on 2-2inch pipe elbows for the inlets. I didn't take the time to make it look real nice, as I was in a hurry and who cares, it's a UDS.

"Good judgment comes from experience, and a lot of that comes from bad judgment." -- Will Rogers
***If you think this post is stupid, dumb, lame then don't read it. Nothing good to say? ....say Nothing and just move on to another post that you freakin like***
Always modifying my smokers, just another addiction.
ebijack is offline   Reply With Quote