Originally Posted by EmilPatrick
Thanks for the reply, you helped convince me that this will definitely be something I can take on myself. It's been quite a while since I've done any serious soldering, but I think I can get the hang of again.
What are you using as a case if any? I've seen several people using the 3D printed models, just curious if there's anything else out there.
Case?ummmm lol a ziplock bag. it works and it keeps the rain out. It rained all day yesterday, it did not have any problems
Yeah the soldering is not really that hard, just use lots of resin flux
Raspberry PI Heatermeter homemade temp controller, 2 UDS.
New Version 4.2 Heatermeter with K thermocouple support Available
PM me, if you would like a HM but aren't sure about soldering or you would like a premade one or if you just want Information about what is needed to make one yourself.