View Single Post
Old 10-20-2013, 07:48 AM   #16
EmilPatrick
Knows what a fatty is.
 
Join Date: 10-04-08
Location: Columbia, MO
Default

Quote:
Originally Posted by Theboz1419 View Post
Well I have had the heatermeter since version 1 and it was much much harder then it is now. Before there was no circuit boards and Raspberry PI, we used Linksys router and wires to connect on the components. The programming was just as bad. took me 6+ months to get one working lol.


But, now the heatermeter can be made by anybody fairly easy, The soldering is the hardest part. The circuit boards have a guide to tell you what goes where on it, and they are numbered, for instance R1 would be resister 1 and if you look at the list of components R1 would be a 1k resister(3 of them) C2 would be a .1u capacitor.

As long as you keep the resisters , caps ect.... in their bags that tell you what they are, you really don't even need to know what they are, if that makes sense. Pictures of the assembly

The programming is as easy as downloading the needed software on your computer as long as you have a SD card slot available, all you have to do install it to the SD card and that it.

Put the Sd card into the RasPI and done, you have yourself a Heatermeter. Byran is constantly updating the software.


And for those that have kids and if they would like to build something, this would be an awesome project for them to learn on.
Thanks for the reply, you helped convince me that this will definitely be something I can take on myself. It's been quite a while since I've done any serious soldering, but I think I can get the hang of again.

What are you using as a case if any? I've seen several people using the 3D printed models, just curious if there's anything else out there.
__________________
Unrefined Swine BBQ Team: Large Spicewine, Three Ugly Drums, WSM, Handful of assorted Webers
EmilPatrick is offline   Reply With Quote


Thanks from:--->