Thread: Building a uds
View Single Post
Unread 09-23-2013, 09:22 PM   #11
wladrules
Full Fledged Farker
 
wladrules's Avatar
 
Join Date: 10-14-11
Location: Bryant, AR
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by J-Rod View Post
^^^DO THIS.

Burning it out will barely touch the chit, and even using stripper takes tons of extra elbow grease to get it all out. I spent the better half of a day laying in my drum with a wire wheel on my grinder getting the last of that chit out-mind you this was after a hot burnout and a stripper treatment too- it farking SUCKED.

I'd gladly pay $50 to get it media blasted if I could do things over.
If only I had a DeLorean...
Yep. That ^^. Drop the change and you'll not have to suffer like I did!
__________________
UDS, COS
wladrules is offline   Reply With Quote