Thread: Building a uds
View Single Post
Unread 09-23-2013, 07:09 PM   #6
J-Rod
is One Chatty Farker
 
J-Rod's Avatar
 
Join Date: 08-15-12
Location: Irish Hills, MI
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by Wneill20 View Post
Fine someone to sand blast it. I did cost me $45. For the inside and out no burning required
^^^DO THIS.

Burning it out will barely touch the chit, and even using stripper takes tons of extra elbow grease to get it all out. I spent the better half of a day laying in my drum with a wire wheel on my grinder getting the last of that chit out-mind you this was after a hot burnout and a stripper treatment too- it farking SUCKED.

I'd gladly pay $50 to get it media blasted if I could do things over.
If only I had a DeLorean...
__________________
UDS'55&16, Akorn, Bar-B-Q Kettle, mini WSM, Drum Grill. I'm JD.
J-Rod is offline   Reply With Quote