View Single Post
Unread 09-20-2013, 07:16 PM   #11430
is one Smokin' Farker
SmokerKing's Avatar
Join Date: 09-07-10
Location: Sunny AZ
Downloads: 0
Uploads: 0

Originally Posted by moe1967 View Post
Drill your intake holes at bottom and burn that bad boy with some old pallets.

Pressure wash, wire wheel left over paint. Then re-paint with high temp paint.
I'd recommend high temp primer b4 paint.

Assemble, then Cook!!
No need to burn out a new unlined drum. Spray and wipe the inside down, assemble.

Rough up the factory paint with a Scotch-brite pad, then spray with high heat Rustoleum 2000 degree black. Use as that as a primer, and then paint whatever non heat resistant color you want over that.
SmokerKing is offline   Reply With Quote