View Single Post
Unread 08-29-2013, 05:11 PM   #11313
Hurricane
Found some matches.
 
Join Date: 10-23-12
Location: Omaha, NE
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by Pasmadj View Post
Hello. I am only up to about page 100, so I apologize if this has been covered and re-covered too much.

I know (from reading this thread) that galvanized parts should not be used inside a UDS unless the galvanized coating is removed chemically or by super-heating.

I have chosen to just avoid using galvanized parts altogether since I don't have a weed-burner, a torch, or the required acid.

I used conduit nuts on the inlet nipples. The package said "Steel". Am I right to assume (now), that they are galvanized steel?

Should I be concerned about the 3 conduit nuts that are way down inside my UDS?

Thanks for any help.
I soaked my conduit nuts in vinegar for a couple day and it took all of the zinc off...like others said, I'm sure its a non-issue, but it's just one less thing to worry about.
Hurricane is offline   Reply With Quote