Originally Posted by Pasmadj
Hello All. I have been working on my UDS for a month or so - whenever spare time allows. My drum is bare cold rolled steel on the inside - a good problem. This weekend I finished most of the painting. I now have some lettering to do.
I notice that there is now a fair amount of rust on the inside of the drum - spotty. When I am finished with the painting, I will bring the drum up to 200 deg to cure the high temp paint. Then, I plan to raise them temp, and then spray inside with oil to season it.
Should I remove the light rust before seasoning?
Yes you should wire brush the inside to remove the rust before seasoning. Also wipe it down well before painting and seasoning, I like to use low odor mineral spirits.
Mini,Jimmy(Jumbo Mini),BP UDS, Kettle, Potbelly Stove Smoker Smoke house, IQ,Guru etc..Keith