View Single Post
Old 08-27-2013, 09:22 AM   #11302
Got Wood.
Join Date: 06-13-12
Location: Charlotte, NC
Default Concerned about a few galvanized parts in my UDS

Hello. I am only up to about page 100, so I apologize if this has been covered and re-covered too much.

I know (from reading this thread) that galvanized parts should not be used inside a UDS unless the galvanized coating is removed chemically or by super-heating.

I have chosen to just avoid using galvanized parts altogether since I don't have a weed-burner, a torch, or the required acid.

I used conduit nuts on the inlet nipples. The package said "Steel". Am I right to assume (now), that they are galvanized steel?

Should I be concerned about the 3 conduit nuts that are way down inside my UDS?

Thanks for any help.
22.5" Weber OTG, 22.5" Weber OTS, Dacor Dual-Burner Nat Gas, UDS (under construction)
Pasmadj is offline   Reply With Quote