View Single Post
Unread 08-26-2013, 09:11 AM   #11301
Got Wood.
Join Date: 06-13-12
Location: Charlotte, NC
Downloads: 0
Uploads: 0
Default Rust on the inside - during build process

Hello All. I have been working on my UDS for a month or so - whenever spare time allows. My drum is bare cold rolled steel on the inside - a good problem. This weekend I finished most of the painting. I now have some lettering to do.

I notice that there is now a fair amount of rust on the inside of the drum - spotty. When I am finished with the painting, I will bring the drum up to 200 deg to cure the high temp paint. Then, I plan to raise them temp, and then spray inside with oil to season it.

Should I remove the light rust before seasoning?
Attached Images
File Type: jpg 130825-7 mid section blue - Small.jpg (29.7 KB, 577 views)
22.5" Weber OTG, 22.5" Weber OTS, Dacor Dual-Burner Nat Gas, UDS (under construction)
Pasmadj is offline   Reply With Quote