View Single Post
Old 08-15-2013, 11:10 AM   #11253
Got Wood.
Join Date: 06-13-12
Location: Charlotte, NC

Originally Posted by spinningwheel View Post

I used 3/4" ball valves and risers. The handle came from a $1.99 mastic glue spreader that I bought at Home Depot. I was looking for handles and really didn't like the choices that they had in hardware, so as I was wandering the store I saw the spreaders and also saw that the handles are screwed to the metal spreader part. I bought a couple of them and took the screws out and had the handles. I cut a couple 1 1/2" pieces of 1/2" conduit for spacers and screwed the handle to the top.
Very creative on the handle. Thanks. I may even have one of those grout spreaders in my garage.

My other question was about the exhaust pipe and fittings in the lid. It looks like you used short pipes and 90s. Did you use conduit nuts on the top and on the underside to secure the pipe?

Are the pipes and 90 deg fittings on the lid 1" diameter?
22.5" Weber OTG, 22.5" Weber OTS, Dacor Dual-Burner Nat Gas, UDS (under construction)
Pasmadj is offline   Reply With Quote