View Single Post
Unread 06-28-2013, 02:39 PM   #7
McGurk
Full Fledged Farker
 
McGurk's Avatar
 
Join Date: 03-26-10
Location: Bloomington, MN
Downloads: 0
Uploads: 0
Default

I built this a few years ago. It's a SS front door from an upright commercial freezer, built on a table made of redwood. I just cut out a hole and left 8 half inch tabs around the inside. I then bent them up and they fit into the gap of the rolled-over rim in the bottom section of the kettle. That way the lid is able to completely close on the rim without touching the table.



__________________
Bad decisions make for good stories!
McGurk is offline   Reply With Quote