View Single Post
Unread 05-18-2013, 01:20 AM   #60
Marvin
Got Wood.
 
Join Date: 02-12-13
Location: Houston, TX.
Downloads: 0
Uploads: 0
Default

I didn't get as far as I would have liked to on the electrical components and box this evening but here is the start of it.

Drilled the hole on the side of the electrical box for the connector to hole the power cord.







I do not plan to hard wire the PID power and SSR connections. I want them to have two prong male plugs so that if I need to remove the PID housing or the electrical box housing from the barrel, I can just unplug. I cut a hole in the other side of the electrical box so that a receptacle could be mounted.





Marvin is offline   Reply With Quote