View Single Post
Unread 05-07-2013, 09:36 AM   #1
sigpi906
Knows what a fatty is.
 
Join Date: 04-05-13
Location: Little Rock, AR
Downloads: 0
Uploads: 0
Default I kinda screwed up my UDS build... Need a solution

It's not the end of the world, but I was new to using a step-bit when drilling the holes for the air intake. As such, the 1/2" nipples do screw in... kinda. But the conduit lock nuts dont hold them on.

So, is there some sort of epoxy or something that I can use to help stabilize the nipples? I don't have access to a welder, and I can use the UDS as it is... but I want it to be "right" and I'm not sure what my options are for getting the nipples to stick.

Side note: I've never typed out the word nipple so many times in my life.
sigpi906 is offline   Reply With Quote


1 members found this post helpful.
Thanks from:--->