View Single Post
Old 04-17-2013, 10:28 AM   #24
On the road to being a farker
Elfmaze's Avatar
Join Date: 03-17-11
Location: Allentown PA

Originally Posted by razrbakcrzy View Post

I can supply a file for a set of hinges I build for flat lids if you are intrested in having some cut out on a cnc or Water jet...
I haven't though about hinging the lids on. The way I usully work around the edge working the lid on tight I wonder if having the hinges would effect the alignment.. I don't suppose it would, But i've had so many problems getting them to seal i am afraid to mess with it.

I don't know any water jet cutters. But If I did it would be scary what i could build :)
Elfmaze is offline   Reply With Quote