View Single Post
Old 04-16-2013, 10:32 PM   #10793
730shooter
Wandering around with a bag of matchlight, looking for a match.
 
Join Date: 07-09-12
Location: nlv,nv
Default

My drum was used for "corn syrup" and has a clear shellac/lacquer type finish on the interior. I tried to burn it out with a weed burner, brush it out with a wire brush on a drill, and paint remover. It there is no way that I can get it to shiny metal without a metal grinder. I think that will make it too rough on the inside and prone to carbon-up. Is there any reason that I need to get that finish off?
730shooter is offline   Reply With Quote