View Single Post
Unread 03-28-2013, 12:37 PM   #10738
Burnuce
Found some matches.
 
Join Date: 03-26-13
Location: Tea, SD
Downloads: 0
Uploads: 0
Default

Hi all,

New here and have been reading through the forums for a couple of weeks now. Going to begin my first UDS build hopefully this weekend if my drum arrives. Thank you to all of you who have posted so much information on process of building one of these. I really appreciate it. I have one question to start and I am hoping someone can give me a little advice.

My drum is food grade (not sure about the liner yet as I haven't seen the drum), but after I burn it out, I am assuming that I should then sand it down both inside an out. I don't have equipment to do this, although I believe I could track one down. How much time does this typically take and would it be worth my time to have someone sandblast it after the burn instead.

Thanks in advance for any advice!
Burnuce is offline   Reply With Quote