View Single Post
Unread 03-11-2013, 10:30 PM   #10678
Singed 'Stache
Found some matches.
 
Join Date: 06-29-12
Location: St. Paul, MN
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by Bigbux58 View Post
Great build... How did you do the springer handle? I can't figure it out?
Thank you. The spring handle is a steel rod slipped through a spring between a steel bracket. The two push nuts (painted yellow) hold the bolt and spring in place. The bracket is fastened to the lid with four 1/2 inch #10 stainless steel bolts. On the back side of the lid where the spring handle bolts come through I fastened a piece of 1" wide steel bar about 6 inches long. This bar is bent in a U-shape to serve as a lid hanger. I had read about some people having trouble with their lid blowing around in a good wind, if it was up, or not wanting to put the greasy thing down on the patio. I find my contraption holds quite solid and perfectly perpendicular.
Singed 'Stache is offline   Reply With Quote