View Single Post
Unread 03-01-2013, 10:39 AM   #10624
arne
Found some matches.
 
Join Date: 01-28-13
Location: Goes, NL, EU
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by Hammer325 View Post
Half way through the post, I was walking into work and noticed an old Weber chimney sitting outside. Thought to my self, " Man there isn't much to that I wonder if there are any posts about making one.". Started reading again and there it was. Great idea.
Thanks. Funny thing, those stainless pots are cheap as chips. Picked both of them up for under 3 bucks new. Just make sure that you cut the underside out from the underside, not from the side. If you do it from below, you leave a little bit of the bend in place to leave some strength in the top one which you need to have it clamp itself it into the bottom one. Took me all of 10 minutes to make.
arne is offline   Reply With Quote