[bfraze99]

Hey, Thanks DW... I am also very excited to see if i can maintain an even heat across the grate... I may have to make a few mods the more i think about it.

I used a 45 deg angle on the inlet which may not be steep enough... i might add a secondary angle to the top.. to shoot the heat up at a steeper angle... but that will require some more tests before we get into that chit...

But then again... i may add another pc at a more obtuse angle to deflect the heat if its too hot at the FB end and to keep any heat from tumbling over the end of the heat deflector... i am not an engineer like i said but i think either can happen if the angle is wrong...

If you have any ideas shoot em at me...

Thanks man!