View Single Post
Unread 02-05-2013, 06:51 AM   #32
Pitmaster T
Babbling Farker
 
Pitmaster T's Avatar
 
Join Date: 04-03-11
Location: Dickinson, Texas
Downloads: 0
Uploads: 0
Default

Thanks so MUCH for sharing this!!!!!!!!!!!!!!!!!!!!!!!!

Quote:
Originally Posted by Neonnblack View Post
I wsa going to buy those, until i saw the 30 dollar price tag a PIECE for a small piece of sheet metal. Mine came out to a 1.75 for four, plus i have enough sheet to make another 4 or 5.

Sheet metal bender:

One side bent all the way, one side after it was out of the bender:

Profile:

Closed:

Open:


I was able to keep a lower consistent temp with these without having to worry about anything falling or moving. A gasket of thin magnet material is behind it (cereal box is also a very good gasket).
Pitmaster T is offline   Reply With Quote