View Single Post
Old 02-04-2013, 07:35 AM   #24
Babbling Farker

dwfisk's Avatar
Join Date: 08-01-12
Location: Fairfield, Florida

When I built my stick burner, I wanted to option of a traditional offset or a reverse flow. So, I had my metal shop cut some tuning plates on their shear - the shear cuts are smooth an let me adjust them with no gap, or space them at increasing widths across the smoker. Mine were about 17" deep and I had a variety of widths cut. With the welded in diverter plate at the firebox it works well and downsizing a little might fit you needs.
dwfisk is offline   Reply With Quote