Thread: UDS Lid help
View Single Post
Unread 01-31-2013, 06:58 PM   #11
knakker123
Is lookin for wood to cook with.
 
Join Date: 01-12-12
Location: Europe Holland
Downloads: 0
Uploads: 0
Default

This is how i did it. My english is a bit rusty but i`ll try to explain. This took me a while (about 30 minutes) but had a nice result. The lid of my barrel was curved around the cilinderend of the barrel . So i used my angle grinder with a fairly rough flap disc to grind off just a mm orso (sorry idk inches) from that `curve` at the side of the barrel.(just the lid layer) The lid came off clean and a perfecly flat barrelcilindertop remained. Carefull! The lid has razor sharp edges when it comes of.
knakker123 is offline   Reply With Quote


Thanks from:--->