View Single Post
Old 12-27-2012, 02:09 PM   #10424
Got Wood.
mike5150's Avatar
Join Date: 07-05-11
Location: Dallas Tx

Originally Posted by Mason Dixon Bowhunta View Post
Okay, I'm a newbie to this site and have become addicted to reading through the many posts on this thread. Lot's of great info, but my ADD is kicking in and I'm wondering about the holes that are drilled into the base of the barrel. They are obviously for air flow, but do you need a valve on each hole? Or do you only only need a valve on one of the holes.
If was going to build another one...I would not use the valve I would use pipe fittings on all three. I seem to always leave it wide open to keep my temp at. 235-250 ish just my 2c

My name is Mike and I approved this message
(1) UDS 2011 Model
mike5150 is offline   Reply With Quote