View Single Post
Unread 12-12-2012, 10:59 AM   #23
Pappy
is Blowin Smoke!
 
Pappy's Avatar
 
Join Date: 05-09-11
Location: Granite City, Illinois (Near St. Louis "GO CARDS")
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by Bluehawg View Post
When using a 1/16" thick cut-off wheel on an angle grinder, you can "score" the line you draw with a marker by lightly touching it to the metal and letting it trench in a bit. After you have done this a few times you can allow it to cut a little deeper and the grinder blade itself will keep your line straight along the mark you have made.

That's what I was trying to say.
__________________
22.5 WSM, 120 Gallon Offset, Weber Performer, IQ-110, ET-732
Pappy is offline   Reply With Quote


Thanks from: --->