View Single Post
Unread 11-22-2012, 12:26 PM   #2
Rando991
Is lookin for wood to cook with.
 
Join Date: 08-29-12
Location: Kansas City Mo
Downloads: 0
Uploads: 0
Default

(above) In the top picture, I put a gage temp probe near the grate and cut 3 holes in the lid and put a Weber damper over it.

(below) Here's the other pics of the mods...

I used Black high temp gasket maker instead of the orange or red (I plan to re-paint the whole cooker this spring).

The Charcoal pan sits on 3 screws where the legs used to be attached.

There is a rubber donut for the probe wires to go thru and you can see on the grill itself I put a little clip with hole to hold the temp probe for the Pitmaster probe.

I had to buy 4 U Bolts to get enough brackets to use on the 2 handles of the grill.

The water pan is not shown, but it has foil, then 3/4 sand, then foil for disposing drippings.

Also, there's no closeup of the wooden handles, but I screwed ends on them to keep the dowel type handles from working out.
Attached Images
File Type: jpg Blower Nozzle.jpg (240.3 KB, 176 views)
File Type: jpg Bottom exterior air pipe.jpg (342.4 KB, 176 views)
File Type: jpg Bottom with pipe.jpg (376.9 KB, 178 views)
File Type: jpg Charcoal pan with holes.jpg (272.0 KB, 177 views)
File Type: jpg Grill and Probe holder.jpg (456.5 KB, 178 views)
File Type: jpg Lid Gasket.jpg (310.9 KB, 176 views)
File Type: jpg Pin Catches.jpg (340.9 KB, 176 views)
File Type: jpg Probe hole.jpg (333.4 KB, 179 views)
Rando991 is offline   Reply With Quote