View Single Post
Old 11-17-2012, 02:06 PM   #3
Full Fledged Farker

Join Date: 03-08-11
Location: Northern NJ

same deal here - thru base/dome on the felt.

I used to run it through the top daisy wheel, but even a 6' probe, it would barely fit, would have to get a high side table to place the thermometer on to create some slack, etc

So now I just go under lid/on top of base, no worries.

If you are using a platesetter - run the probe wire over the "leg" and out the smoker so to speak - helps shield the wire probe from direct heat.
eggzlot is offline   Reply With Quote