Thread: First UDS Build
View Single Post
Unread 09-15-2012, 08:09 PM   #28
Sampler
Knows what a fatty is.
 
Join Date: 09-03-12
Location: South Portland, Maine
Downloads: 0
Uploads: 0
Default

Another problem...

My lid is too small for my drum. There is about a 1/4 gap all around the lid when holding over the drum even if I was to use the bottom ring from the charcoal cooker it doesn't fit. I was thinking about using the original cover of the drum and then customizing it to fit my lid by riveting the two of them together after I cut the center out of the cover.

Any thoughts? Good bad and "ugly"?
Sampler is offline   Reply With Quote