View Single Post
Unread 07-29-2012, 07:12 AM   #1
smokingbarrel
Is lookin for wood to cook with.
 
Join Date: 07-15-12
Location: Fairfax VA
Downloads: 0
Uploads: 0
Default New vent controls on my UDS

Had my fist smoke last night on my new UDS I built. Ribs came out great but I need to rethink my setup for air ventilation.

I have 4 1.5" holes drilled around the bottom of the drum. I tried using magnets that I could slide around to get the right control. It worked, but not as well as I would have liked. Should I go with the common approach and drop in threaded nipples that can be capped off? Anyone seen other good ways to open and shut the holes?
smokingbarrel is offline   Reply With Quote