I just ordered and received the CyberQ wifi. I noticed the instructions were for version 1.0 of the firmware but my CyberQ still had .8 installed.
I was able to set it up in ad hoc instantly -- will try to do the infrastructure with my router later this evening.
BTW -- is there a way to reset this thing to factory defaults in case I screw up the router config? I'm afraid of moving it from ad hoc to infrastructure and then discovering I can't communicate with it anymore. Can I reset it from the keypad?
(I had all about 10 minutes to look at it yesterday -- test the unit and fan -- but I haven't been able to spend much time with it. The web pages seem to come up very slow -- very annoying. I noticed that when I was browsing the config screens on my iPhone.)