View Single Post
Unread 07-22-2012, 01:56 PM   #3
FlashJim
On the road to being a farker
 
FlashJim's Avatar
 
Join Date: 07-08-12
Location: Houston, TX
Downloads: 0
Uploads: 0
Default

The next thing to remove is the tool holder. It's held on by four 1/2" nuts.



The control panel door is held on by two 1/2" nuts and two tabs.


Four bolts are removed to allow the kettle bowl to be lifted out.



Lift the front and rear panels straight up to remove them.


I dropped the kettle bowl back into the frame to make it easier to clean.


A 1/2" socket is used to remove three nuts that fasten the lid holder to the bowl.



The ash catcher ring is removed by releasing the three tabs behind each leg stub on the kettle bowl.
FlashJim is offline   Reply With Quote