View Single Post
Old 07-18-2012, 11:41 AM   #12
On the road to being a farker
Join Date: 06-12-12
Location: Louisville,KY

Originally Posted by daninnewjersey View Post
Take a pair of plyers and flatten out the edge of the lid. It will chip the paint but you can spray high temp paint on the exposed metal. Place the lid on the drum, tap any uneven parts of the lip with a hammer and wood block.
This is easier done than typed!!! The only down side is the idea of tearing up something ya just bought. Easier fix than the flat bar mod, or the grind the drum top ridge mod.
Homemade offset stick-burner, UDS -- sorta slow Deltatrak , Maverick ET-732
DJnKY is offline   Reply With Quote

Thanks from:--->